Open box new, Crestron DMPS Lite 4K Multiformat 2×1 AV Switch and Receiver.
Description
The Crestron HD‑RX‑4K-210-C-E is a multiformat AV switch and receiver that provides HDMI® video switching and audio presentation capabilities in areas such as conference rooms and classrooms. Compatible with all DM Lite® transmitters, the HD‑RX‑4K-210-C-E provides one DM Lite input for connection to one transmitter.
- Crestron Switch/Receiver
- Universal Power Adapter with various adapters supporting US and INTL voltages (PW-2412WU)
- Wall mount accessories (see last picture)
Video:
|
| Switcher |
2×1 auto-switching or manual, audio-follows-video, Crestron Auto-Locking® and QuickSwitch HDâ„¢ technologies |
| Scaler (HDMI Output) |
4K video scaler with intelligent frame rate conversion, Deep Color support, content-adaptive noise reduction, 3:2/2:2 pull-down detection and recovery |
| Input Signal Types |
HDMI with Deep Color and 4K (DVI and Dual Mode DisplayPortâ„¢ interface compatible2) on Input 1, DM Lite with Deep Color and 4K on Input 2 |
| Output Signal Types |
HDMI with Deep Color and 4K (DVI compatible3) |
| Copy Protection |
HDCP 2.2 |
| Maximum Resolutions |
Common resolutions are listed below for the HDMI and DM Lite inputs. |
Scan
Type |
Resolution |
Frame
Rate |
Color
Sampling |
Color
Depth |
| Progressive |
4096×2160 DCI 4K and 3840×2160 4K UHD |
24 Hz |
4:4:4 |
30 bit |
| 30 Hz |
4:4:4 |
24 bit |
| 30 Hz |
4:2:2 |
36 bit |
| 60 Hz |
4:2:0 |
24 bit |
| 2560×1600 WQXGA |
60 Hz |
4:4:4 |
36 bit |
| 1920×1080 HD 1080p |
60 Hz |
4:4:4 |
36 bit |
|
Audio:
| Input Signal Types |
HDMI (Dual-Mode DisplayPort compatible2), DM Lite |
| Output Signal Types |
HDMI, stereo analog |
| Digital Formats |
2-channel LPCM |
| Analog Formats |
Stereo 2-channel |
| Digital-to-Analog Conversion |
24-bit 48 kHz |
| Output Impedance |
200 ohms balanced, 100 ohms unbalanced |
| Maximum Output Level |
4 Vrms balanced, 2 Vrms unbalanced |
| Output Volume |
-80 to +20 dB level adjustment range plus Mute |
| Mute |
Enable or disable independently for HDMI and analog audio output |
| Analog Output Performance |
Frequency Response: 20 Hz to 20 kHz ±0.5 dB
S/N Ratio: >95 dB @ 10 dBV, 20 Hz to 20 kHz, A-weighted
THD+N: <0.005% @ 1 kHz and 10 dBV
Stereo Separation: 20 Hz to 20 kHz ≤80 dB |
| Acoustic Noise |
Not applicable (fanless) |
Connectors:
|
| HDMI INPUT 1 |
(1) HDMI Type A connector, female;
HDMI digital video/audio input;
DVI and Dual-Mode DisplayPort interface compatible2 |
| DM Lite INPUT 2 |
(1) 8-pin RJ-45 yellow connector, female, shielded;
DM Lite input port for connection to a DM Lite transmitter |
| HDMI OUTPUT |
(1) HDMI Type A connector, female;
HDMI digital video/audio output;
DVI compatible3 |
| NOTE: CEC over the HDMI output provides Power On/Off control of the display device without a control system or full programmable control of any device with a control system. |
| AUDIO L/R |
(1) 5-pin 3.5 mm detachable terminal block;
Balanced/unbalanced stereo line-level audio output;
Maximum Output Level: 4 Vrms balanced, 2 Vrms unbalanced;
Output Impedance: 200 ohms balanced, 100 ohms unbalanced |
| Ethernet |
(1) 8-pin RJ-45 connector, female;
100BASE-TX/1000BASE-T Ethernet port |
| I/O 1-2 |
(2) 2-pin detachable terminal blocks;
Comprised of 2 Versiport digital input/output or analog input ports (referenced to GND);
Digital Input: Rated to 0-24 VDC, input impedance 20k ohms, logic threshold >3.125 V low/0 and <1.875 V high/1;
Digital Output: 250 mA sink from maximum 24 VDC, catch diodes for use with real world loads;
Analog Input: Rated for 0-10 VDC, protected to 24 VDC maximum, input impedance 21k ohms with pull-up resistor disabled;
Programmable 5 V, 2k ohms pull-up resistor per pin |
| RELAY 1-2 |
(2) 2-pin detachable terminal blocks;
Comprised of 2 normally open, isolated relays;
Rated 1 A, 30 VAC/VDC;
MOV arc suppression across contacts |
| IR |
(1) 2-pin 3.5 mm detachable terminal block;
IR output control port; supports IR up to 60 kHz;
IRP2 emitter sold separately |
| NOTE: The IR port provides Power On/Off control of the display device with the use of a control system. |
| COM |
(1) 5-pin 3.5 mm detachable terminal block;
Bidirectional RS-232 port;
Supports RS-232 up to 115.2k baud with hardware and software handshaking |
| NOTE: The COM port provides Power On/Off control of the display device without a control system or full programmable control of any device with a control system. |
| 24V 1.25A |
(1) 2.1 x 5.5 mm DC power connector;
24 VDC power input;
PW-2412WU power pack included |
| NOTE: The power pack powers both the HD-RX-4K-210-C-E and the connected DM Lite transmitter. A power pack must not be connected to both devices simultaneously. When paired with a 4K60 4:4:4 (4KZ) transmitter, power must be connected to the HD-RX-4K-210-C-E only. |
| SERVICE |
(1) USB Type A connector, female;
For factory use only |
Shipping:
- Carrier will be Fedex or UPS Ground for free shipping
- Please note USPS is required for PO Boxes
- Free 1-day handling for shipping.
- Signature will be required for orders of qty 2 or more. No exceptions can be made.
Returns: To qualify for a free return all items must be in unused condition.
New items must be unused and in new (sealed if applicable)
Used items must be unused as well. I.e. SSDs have no additional data written.
A restocking fee will apply for any signs of usage.
Don’t hesitate to ask if you have any questions.
Thanks for looking!
|
Reviews
There are no reviews yet.